Production requirements of wafer connectors

We all know that the role of the wafer connector is to arrange the contacts according to the required position and spacing, to ensure the insulation between the contacts and the contact between the shell. Then insulation performance and voltage resistance performance are people's performance requirements for the production of materials for wafer connector. After various processing processes, the production of wafer pin holder connector also needs to meet the relevant production requirements. The following describes several performance requirements.

One is the flatness requirement. Each terminal on the wafer connector must be on a horizontal plane, no jagged phenomenon. This requires the factory to do a good job of packaging when producing. The terminals on the connector of wafer pin seat are relatively prone to position deviation caused by problems such as movement. When the connector is produced, it should be immediately packed with appropriate packaging materials and placed in packaging cartons.

The second is the finish requirement. The wafer connector is a connecting element whose smoothness determines the stability of its insertion force. The processing of raw materials should be in place to avoid the problem of rough surface. At the same time, it is also necessary to ensure the cleanliness of the wafer connector production workshop, ensure that there will be no pollution problems such as ash accumulation after the production of terminal components, and ensure the cleanliness of its surface.

Third, hardness requirements. When choosing the raw materials for wafer connector, it is necessary to meet the requirements of hardness and tensile strength. Only when these two requirements are met can the pulling force of terminals reach the relevant standards of our country. According to the actual production of wafer pin seat connector on the market at present, the hardness of the general connector should reach 180~210Hv, tensile strength is 58~65kgf/mm2.